Infors Multitron - Clamps and Other Holders; Clamps

Multitron - Incubation Shaker
Accessories
25 February 2019 Page 59 of 146
5.2 Clamps and Other Holders
For individual fitting of the universal table tray, various clamps and
holders are available.
ATTENTION
The clamps and holders are fixed to the tray using screws. If
screws that are too long are used, these will stick out of the bot-
tom of the tray. This has the effect that the tray can no longer be
inserted and affixed correctly.
If you have to replace lost fastening screws, you must use screws
that have the same length as the original screws.
5.2.1 Clamps
The clamps of various sizes required for individual fitting can be
ordered separately to be assembled by users.
Stainless steel clamps
The following stainless steel clamps are available:
For flask type Volume
Erlenmeyer
25 mL
500 mL
4000 mL
50 mL
1000 mL
5000 mL
100 mL
2000 mL
250 mL
3000 mL
Fernbach
1800 mL
2800 mL
Plastic clamps
The following plastic clamps are available:
For flask type Volume
Erlenmeyer 100 mL 250 mL 500 mL