Inovance MD800 Series - Page 246

Parameter Group
-245-
Max.: 208 Data type: UInt16
Default:
0
Change:
At stop
Value Range:
0: Not selected
1: Power supply unit - DI1
2: Power supply unit - DI2
3: Power supply unit - DI3
4: Power supply unit - DI4
5: Power supply unit - DIO1
6: Power supply unit - DIO2
7: Power supply unit - DIO3
8: Power supply unit - DIO4
101: Extension card 1 - DI1
102: Extension card 1 - DI2
103: Extension card 1 - DI3
104: Extension card 1 - DI4
105: Extension card 1 - DI5
106: Extension card 1 - DI6
107: Extension card 1 - DI7
108: Extension card 1 - DI8
201: Extension card 2 - DI1
202: Extension card 2 - DI2
203: Extension card 2 - DI3
204: Extension card 2 - DI4
205: Extension card 2 - DI5
206: Extension card 2 - DI6
207: Extension card 2 - DI7
208: Extension card 2 - DI8
Description
This parameter defines the source of the input terminal.
F4-01
DI1 function selection
Address:
62465
Min.:
0
Unit:
-
Max.: 63 Data type: UInt16
Default:
1
Change:
At stop
Value Range:
0 to 63
Description
This parameter defines the function of the input terminal.
0: No function
Set 0 for reserved terminals to avoid malfunction.
1: Forward RUN (FWD) or running command
When two-wire mode 1 is selected (F4-17 = 0), the terminal is used to set the AC drive to forward run.
When two-wire mode 2 is selected (F4-17 = 1), the terminal is used to give a running command.
2: Reverse RUN (REV) or running direction
When three-wire mode 1 is selected (F4-17 = 2), the terminal is used to set the AC drive to reverse run.
When two-wire mode 2 is selected (F4-17 = 3), the terminal is used to set the running direction.