Software Tools
-418-
Figure 3-3 Viewing parameters
Note the following when viewing status parameters:
● When the AC drive is running, you can press
to view status parameters. The following status
parameters are displayed by default: running frequency, frequency reference, bus voltage, output
voltage, and output current. To view more status parameters, see description of F7-03 and F7-04 in
“
3.1.2 Related Parameters
”
on page 413
.
● When the AC drive stops, you can press
to view status parameters. The following status
parameters are displayed by default: frequency reference, bus voltage, AI1 voltage, and AI2 voltage.
To view more status parameters, see description of F7-05 in “
3.1.2 Related Parameters
”
on page 413
.
3.1.5 Fault and Alarm Display
When the equipment fails, the fault indicator is steady on, and the equipment immediately stops
outputting. The operating panel displays the fault code, as shown in the following figure. Find and
remove the fault cause. Then, reset the fault.
Figure 3-4 Fault code displayed on the operating panel
To Next Page
Loading...
