Inovance MD800 Series Function Guide

Parameter Group
-346-
FE-30
User-defined parameter 30
Address:
65054
Min.:
0
Unit:
-
Max.: 0 Data type: UInt16
Default:
0
Change:
At once
Value Range:
-
Description
Group FE consists of user-defined parameters. Users can add commonly used parameters to group FE
for easier check and modification.
FE-31
User-defined parameter 31
Address:
65055
Min.:
0
Unit:
-
Max.: 0 Data type: UInt16
Default:
0
Change:
At once
Value Range:
-
Description
Group FE consists of user-defined parameters. Users can add commonly used parameters to group FE
for easier check and modification.
2.16 FP: User Parameters
FP-00
User password
Address:
7936
Min.:
0
Unit:
-
Max.: 65535 Data type: UInt16
Default:
0
Change: Unchangeable
Value Range:
0 to 65535
Description
After the password is set, the password is required when the operating panel of the power supply unit
is used to control the drive unit.
FP-01
Parameter initialization
Address:
7937
Min.:
0
Unit:
-
Max.: 501 Data type: UInt16
Default:
1
Change:
At once
Value Range:
0: No operation
1: Restore factory defaults mode 1
2: Clear records
4: Back up current user parameters
501: Restore user backup parameters
Description
This parameter is used to set the corresponding action upon parameter initialization of the AC drive.
0: No operation
The AC drive does not perform any operation.

Inovance MD800 Series Specifications

General

Input Voltage	3-phase 380V AC ±15%
Output Voltage	0 to input voltage
Output Current	Depends on model
Power Range	0.75 kW to 500 kW
Control Mode	V/F control, vector control
Communication	Modbus
Protection	Overcurrent, overvoltage, undervoltage, overload, overheat
Operating Temperature	-10°C to +50°C
Storage Temperature	-20°C to 60°C
Humidity	5% to 95% (non-condensing)
Altitude	Up to 1000m without derating