Inovance MD800 Series - FC: Multi-Reference and Simple PLC

Parameter Group
-324-
2.13 FC: Multi-Reference and Simple PLC
FC-00
Multi-reference 0
Address:
64512
Min.:
–100.0
Unit:
%
Max.: 100.0 Data type: Int16
Default:
0.0
Change:
At once
Value Range:
–100.0% to 100.0%
Description
This parameter defines the frequency reference of each speed. FC-00 to FC-15 correspond to a total of
16 frequency setpoints for 16 segments numbered from 0 to 15. The frequency setpoint is calculated
as a percentage to the maximum frequency. The value 100% corresponds to F0-10 (maximum
frequency). The AC drive provides four multi-reference terminals, which provide 16 state
combinations, corresponding to 16 frequency setpoints.
When the simple PLC is used as the main frequency source, you need to set parameters in group FC.
In some industrial applications, the AC motor is only used to implement simple functions including
start/stop, timed and segmented speed regulation, and automatic forward and reverse running. With
the simple PLC, you can implement other control functions without adding a physical PLC. The simple
PLC is generally used in industrial equipment such as mixture mixing and industrial washing
machines.
When the simple PLC is used as the main frequency source (F0-03 = 7), you need to set the parameters
in group FC.
FC-01
Multi-reference 1
Address:
64513
Min.:
–100.0
Unit:
%
Max.: 100.0 Data type: Int16
Default:
0.0
Change:
At once
Value Range:
–100.0% to 100.0%
Description
Same as FC-00
FC-02
Multi-reference 2
Address:
64514
Min.:
–100.0
Unit:
%
Max.: 100.0 Data type: Int16
Default:
0.0
Change:
At once
Value Range:
–100.0% to 100.0%
Description
Same as FC-00
FC-03
Multi-reference 3
Address:
64515
Min.:
–100.0
Unit:
%
Max.:
100.0
Data type:
Int16
Default:
0.0
Change:
At once
Value Range:
–100.0% to 100.0%