Inovance MD800 Series - List of Drive Unit Parameters

List of Drive Unit Parameters
Table –1 Function parameters of drive unit
Para.
No.
Address
Name
Value Range
Default
Unit
Change
Page
F0-00 61440
G/P type
1: G type (constant-torque load)
2: P type (fan and pump)
Model
dependent
-
Unchangeable
“
F0-00 ”
on page
210
F0-01 61441
Motor 1 control mode
0: SVC
1: Reserved
2: V/f control
3: Reserved
4: Reserved
5: VC++
2 -
At stop
“
F0-01 ”
on page
210
F0-02 61442
Command source
0: Operating panel of the power supply
unit/LCD operating panel/Software
tool
1: Terminal
2: Communication
0 -
At stop
“
F0-02 ”
on page
210
F0-03 61443
Main frequency source X
0: Digital setting (preset frequency (F0-
08) that can be changed by pressing
UP/DOWN, non-retentive upon power
failure)
1: Digital setting (preset frequency (F0-
08) that can be changed by pressing
UP/DOWN, retentive at power failure)
2: AI1
3: AI2
4: AI3
5: Reserved
6: Multi-reference
7: Simple PLC
8: PID
9: Communication
10: Reserved
0 -
At stop
“
F0-03 ”
on page
211
F0-04 61444
Auxiliary frequency
source Y
0: Digital setting (preset frequency (F0-
08) that can be changed by pressing
UP/DOWN, non-retentive upon power
failure)
1: Digital setting (preset frequency (F0-
08) that can be changed by pressing
UP/DOWN, retentive at power failure)
2: AI1
3: AI2
4: AI3
5: Reserved
6: Multi-reference
7: Simple PLC
8: PID
9: Communication
10: Reserved
0 -
At stop
“
F0-04 ”
on page
212
List of Drive Unit Parameters
-139-