Inovance MD800 Series - Page 274

Parameter Group
-273-
Description
This parameter defines the trial current for speed tracking of the synchronous motor. The default
value is recommended.
F6-31
Minimum tracking frequency for synchronous motor speed tracking
Address:
63007
Min.:
0.0
Unit:
Hz
Max.: 100.0 Data type: UInt16
Default:
0.0
Change:
At stop
Value Range:
0.0 Hz to 100.0 Hz
Description
This parameter defines the minimum speed tracking frequency for the synchronous motor. The
default value is recommended.
F6-32
Angle compensation for synchronous motor speed tracking
Address:
63008
Min.:
0
Unit:
-
Max.: 360 Data type: UInt16
Default:
0
Change:
At stop
Value Range:
0 to 360
Description
This parameter defines the angle compensation for speed tracking of the synchronous motor. The
default value is recommended.
F6-33
Proportion coefficient of synchronous motor speed tracking
Address:
63009
Min.:
0.1
Unit:
-
Max.: 10.0 Data type: UInt16
Default:
2.0
Change:
At stop
Value Range:
0.1 to 10.0
Description
This parameter defines the proportion coefficient of speed tracking of the synchronous motor. The
default value is recommended.
F6-34
Integral coefficient of synchronous motor speed tracking
Address:
63010
Min.:
0.1
Unit:
-
Max.: 10.0 Data type: UInt16
Default:
6.0
Change:
At stop
Value Range:
0.1 to 10.0
Description
This parameter defines the integral coefficient of speed tracking of the synchronous motor. The
default value is recommended.
F6-35
Reverse running inhibition for flying start
Address:
63011
Min.:
0
Unit:
-
Max.: 2 Data type: UInt16