Software Tools
-412-
Status Indicators
The status indicators are on the drive unit.
Table 3–2 Indicators on the drive unit
Symbol
Name Status
PWR (yellow) Power indicator Steady ON: The device is powered on.
OFF: The device is powered off.
RUN (green)
RUN indicator Steady ON: The device is running.
OFF: The device is stopped.
Blinking: The device is operated through the
operating panel of the power supply unit.
ERR (red)
Alarm indicator Steady ON: The device is faulty.
OFF: The device is normal.
Blinking: An alarm is generated.
Data Display
● Axis number display area
Two-digit LED display is used: 0 indicates the power supply unit and 1 to 8 indicates the drive units.
● Status display area
Table 3–3 Status icons
Icon Name
Function
Status
Axis (AXIS)
Axis switchover
key
-
Torque control (TC) Torque control
mode
Steady ON: The torque control mode is used.
Blinking: Auto-tuning is in progress.
Forward (FWD)
Forward running
-
Reverse (REV)
Reverse running
-
Wi-Fi Wi-Fi connection
mode
-
Remote Remote
connection mode
Steady ON: terminal control as command
source
Blinking: communication control as command
source
Alarm Alarm state Steady ON: The device is faulty.
Blinking: An alarm is generated.
Run
Running state
-
Stop Stop state
-
● Data display area
Five-digit data is displayed on the LED display of the operating panel. The data is used to indicate
the frequency reference, output frequency, various monitoring data, and fault codes.
● Unit display area
To Next Page
Loading...
