Function Applications
-540-
Table 4–49 Mapping between monitoring parameters and bytes of F7-03, F7-04, and F7-05
Para. No. Name
Default
Value Range Description
F7-03
LED display 1
in running
state
1F 0000 to FFFF
To display a parameter during running, set the
corresponding bit to 1, convert the binary
number to a hexadecimal equivalent, and set it
in F7-03.
F7-04
LED display 2
in running
state
0 0000 to FFFF
To display a parameter during running, set the
corresponding bit to 1, convert the binary
number to a hexadecimal equivalent, and set it
in F7-04.
F7-05
LED display in
stop state
33 0000 to FFFF
To display a parameter upon stop, set the
corresponding bit to 1, convert the binary
number to a hexadecimal equivalent, and set it
in F7-05.
Note
When the AC drive is powered on again after power-off, the parameters selected before power-off are displayed.
The monitoring parameters corresponding to each bit in F7-03, F7-04, and F7-05 do not completely correspond to
all the monitoring parameters in group U0. If parameters to be monitored cannot be found in F7-03, F7-04 and F7-
05, view them in group U0.
To Next Page
Loading...
