2 Micromate Operator Manual – 721U0201 Revision 6
1.4. Handling Precautions
Handle all equipment and accessories with care.
Do not operate the equipment if the enclosure has been damaged. Immediately turn the
instrument off and have it inspected by an authorized Instantel repair facility.
Use only the recommended Instantel AC Adapter. Use of alternate power sources are not
recommended for this instrument and may incorrectly set polarity, cause overheating
and/or distortion, fire, electrical shock, or other hazards.
Ensure that the AC Adapter is fully inserted and rated for the AC supply voltage of the
outlet.
Ensure the connectors are clean prior to each use.
To ensure proper operation charge the battery immediately when the Micromate indicates
a low battery condition. The Micromate can be kept on charge without damaging the
battery.
The battery used in this device may present a fire or chemical burn hazard if mistreated.
DO NOT disassemble the battery, heat it above 100°C (212 °F) or incinerate.
Disconnect the battery if storing for prolonged periods of time or shipping by commercial
courier. Do not open the unit.
Do not pull on the cord when connecting or disconnecting cables. Align the connector to the
port before inserting. Never force a connector.
Ensure you are attaching the cable or device to the proper connector.
The Micromate is water-resistant. Do not immerse in water. Clean with a damp cloth.
1.5. Micromate ISEE and DIN Models
The Micromate unit and geophone are factory calibrated as a system to either the International
Society of Explosives Engineers (ISEE) or Deutsches Institut fur Normung (DIN) 45669-1 standards,
but not to both. The Micromate and geophone Model/Serial number labels will be exactly the
same and carry the designation of ISEE or DIN. The geophone cannot be swapped with any other
Micromate unit as the calibration would no longer be valid.
Micromate ISEE Model
To Next Page
Loading...
