Instantel Micromate - Maintenance

124 Micromate Operator Manual – 721U0201 Revision 6
16. MAINTENANCE
The Micromate does not contain any user serviceable parts, other than what has been listed below,
and therefore is not to be opened. Any attempt to open the unit, geophone or microphone will
void any and all warranties offered by Instantel. Additionally, the tampering or removal of the
geophone labels will void any and all warranties. The user maintenance is limited to the following
items:
 Reload Operating System: Instantel will, from time to time, release new versions of the
Micromate’s operating system. To upgrade the unit’s operating system, install the new
version of the Blastware program on your computer and connect the Micromate unit to
your PC. Using the Blastware program select Unit/Reload Operating System. Detailed
instructions are provided in the Blastware Operator Manual.
 Periodic Cleaning: Use a soft cloth dampened with water and or a vacuum to remove any
dust, dirt and sand from the Micromate unit, protective boot, geophone, microphone
(including cables) and carrying case. DO NOT use paint thinners or Ketone solvents as these
will damage the Micromate and protective boot. To avoid scratching, do not scrub any of
the surfaces with abrasive cleaners, cleaning pads or stiff brushes.
 Replace Dust Caps: This does not require the Micromate to be opened. Carefully remove
the three screws, support bar and damaged dust cap from the end of the unit. Replace the
old dust cap with the new one and replace the support bar and screws. DO NOT over
tighten the screws. Replacement dust caps are only available through your authorized
Instantel dealer.
 Replace Power Adapter: If required, replacement power adapters are available through
your Instantel dealer.
 Storage: When storing the Micromate for an extended period of time, ensure the battery
has been charged for at least 24 hours. Then use the Maintenance menu or press and hold
the power button for five seconds to disconnect the internal battery.
Refer to the section 1.4 Handling Precautions prior to performing any maintenance procedures.