Instantel Micromate - Page 135

Micromate Operator Manual – 721U0201 Revision 6 127
Condition
Probable Cause
Corrective Action
The Longitudinal channel fails the
sensor check.
The geophone is not connected.
Connect the geophone.
The geophone is not level.
Check the geophone is level from front to
back.
The geophone moved during the Sensor
Check.
Press the Sensor Check key to run Sensor
Check again. Do not touch the geophone.
The geophone cable is improperly
installed or damaged.
Check the geophone cable cuts, crimps or
damage. Check the cable connection.
Damaged geophone.
Have the geophone checked by an authorized
Instantel service facility.
The Microphone fails the sensor
check.
Microphone not connected.
Connect the microphone.
Damaged microphone or microphone
cable.
Have the microphone checked by an
authorized Instantel service facility.
Blastware is not able to communicate
with the Micromate.
Blastware has not been setup correctly.
Make sure the correct unit type has been
selected (bottom left of the Blastware
window).
Make sure to use Blastware version 10.7 or
higher.
Make sure the communication cable has not
been damaged.
Wrong version of Blastware is being
used.
Unable to communicate over a
modem.
Blastware has not been setup correctly.
Make sure the proper cable is used and
connected between the unit and the modem.
Ensure the unit is configured to communicate
over a modem.
Ensure the proper IP address is being used.
Unit does not respond to key presses.
The Micromate has not been turned on.
Press and hold the power button for five
seconds.
The charge status LED does not turn
on with an external power source.
Improper power source.
Ensure the recommended adaptor is used.
Replace the adaptor.
The Save icon is not available with a
memory stick inserted.
Wrong formatting on the memory stick
Reformat the memory stick to Fat 16 or FAT
32.
Memory stick not inserted properly
Remove and reinsert the memory stick
The Printer icon is not available when
the printer is connected.
Unsupported printer has been
connected.
Ensure the proper printer is connected.
The printer is not turned on.
Make sure the printer has been powered on.
The Printer cable is damaged.
Make sure the cable has not been damaged
and is connected properly.
The GPS icon is not available with the
GPS connected.
Unsupported GPS has been connected.
Ensure the proper GPS is connected.
The GPS is not turned on.
Make sure the GPS has been powered on.
The GPS cable is damaged.
Make sure the cable has not been damaged
and is connected properly.
The remote alarm does not sound the
external alarms.
The remote alarm has not been
configured properly.
Verify the remote alarm setups.
No external power to the sounder or
light.
Make sure the external power to the sounder
or light has been connected properly.