Chapter 2 Login 16
If the preceding page does not appear, please try the following methods:
− Ensure that the CPE is powered on properly.
− Ensure that the computer is connected to the LAN port of the CPE properly.
− Ensure that the IP address of the computer is in the same network segment of the CPE’s IP address. For
example, if the default IP address of the CPE is 192.168.2.1, you can set the IP address of the computer
to 192.168.2.X (X ranges from 2 to 254 and is not occupied).
− If more than one CPE is connected, please modify the IP address of each one to avoid the failure to log
in to the web UI of the CPE due to IP address conflict.
− Reset the CPE to factory settings. Reset method: With the CPE powered on, hold down the reset button
for about 8 seconds, and then release it when all indicators light up and then turn off. The CPE is
restored to factory settings successfully.
----End
After successful login, the following page appears.
To Next Page
Loading...