Chapter 4 Quick setup 34
(4) Enter the WiFi password you set on CPE1 in the Key text box, and click Next.
(5) Set the IP address to an unused IP address belonging to the same network segment as
that of CPE1. Then set the Subnet Mask to the same one of the peer device, and click
Next.
For example, if the IP address of CPE1 is 192.168.2.1, you can set the IP address of the
device to 192.168.2.X (X ranges from 2 to 254).
(6) Click Save, and wait until the CPE reboots to activate the settings.
----End
When LED1, LED2, and LED3 of CPE1 are solid on, and LED1, LED2, and LED3 of CPE2 are
blinking, the bridging succeeds.
To Next Page
Loading...