Chapter 4 Quick setup 38
Parameters description
It specifies the wireless network name (SSID) of the upstream AP.
It specifies the operating channel of the WiFi network to be bridged. It will be
automatically populated when you select an SSID to bridge.
It specifies the security mode of the WiFi network to be bridged. It will be
automatically populated when you select an SSID to bridge. If the WiFi network to be
bridged has a WiFi password, you need to enter the password manually.
5. Set the IP address to an unused IP address belonging to the same network segment as that of
the upstream AP. For example, if the IP address of the upstream AP is 192.168.2.1, you can set
this device’s IP address to 192.168.2.X (X ranges from 2 to 254). Then click Next.
6. Click Save, and wait until the CPE reboots to activate the settings.
To Next Page
Loading...