IP-COM CPE6S - Page 74

Chapter 4 Quick setup 66
Parameters description
Name
Description
Peer AP1
It specifies the wireless network name (SSID) of the first peer AP.
MAC Address of
Peer AP1
It specifies the MAC address of the first wireless network to be bridged.
Channel
It specifies the operating channel of the WiFi network to be bridged. It will be
automatically populated when you select an SSID to bridge.
Security Mode
It specifies the security mode of the WiFi network to be bridged. It will be
automatically populated when you select an SSID to bridge.
Tip
The P2MP mode only supports WEP and None security modes.
(5) Click Next on the following page.
(6) Click Save, and wait until the device reboots to activate the settings.