5－34
JMA-9100 Instruction Manual > 5.OPERATION OF TARGET TRACKING AND AIS > 5.3 AIS OPERATION
Procedures
1) Left-click the AIS filter mode switching in Target Information
located at the upper right of the display, and select the filter to be
set.
The AIS filter will be selected.
5.3.7.3 Creation of AIS Filter (Make AIS Filter)
Procedures
1) Open the AIS Filter Setting menu by performing the following
menu operation.
→
2) Left-click .
The mode to make an AIS filter will be activated.
[1] Setting Range Filter
3) Set a filter range by turning the [VRM] dial, and left-click.
[2] Setting Sector Filter
3) Set a starting bearing by turning the [EBL] dial, and left-click.
4) Set an ending bearing by turning the [EBL] dial, and left-click.
[3] Setting Zone Filter
3) Set a starting bearing and range by turning the [EBL] dial and
[VRM] dial, and left-click.
AIS
4. AIS Filter Setting
2. Make AIS Filter
To Next Page
Loading...
