Keithley 2510

10-8 SCPI Command Reference Models 2510 and 2510-AT User’s Manual
:SOURce[1]
:RESistance
[:LEVel] ✓
[:IMMediate] ✓
[:AMPLitude] <n> Set resistance level. <n> =1 to 1.000e3 (Ω)
for 100Ω thermistor, 1 to 250 (Ω)
for 100Ω RTD, 5 to 9.999e3
(Ω) for 1kΩ thermistor, 5 to 3.000e3 (Ω)
for 1kΩ RTD, 50 to 8.000e4 (Ω) for 10kΩ
thermistor, 500 to 2.000e5 (Ω) for 100kΩ
thermistor | MIN |MAX | DEF
100 (100Ω RTD
or ther),
1e3 (1kΩ RTD
or ther),
1e4 (10kΩ ther), or
1e5 (100kΩ ther)
✓
[:AMPLitude]? Query resistance level. ✓
:PROTection Set resistance protection. ✓
[:HIGH] Upper resistance limit.
[:LEVel] <n> Set upper resistance limit.
<n> 50 to 1.000e3 (Ω) for 100Ω
thermistor, 50 to 250 (Ω) for
100Ω RTD, 500 to 9.999e3 (Ω) for 1kΩ
thermistor, 500 to 3.000e3 (Ω) for
1kΩ RTD, 5.000e3 to 8.000e4 (Ω) for 10kΩ
thermistor, 5.000e4 to 2.000e5 (Ω) for 100kΩ
thermistor | MIN (LOW:LEV) | MAX | DEF
200 (100Ω RTD
or ther),
2e3 (1kΩ RTD
or ther),
2e4 (10kΩ ther), or
2e5 (100kΩ ther)
[:LEVel]? Query upper protection resistance limit.
:TRIPped? Query if upper limit is exceeded.
(1 = yes; 0 = no).
:LOW Lower resistance limit.
[:LEVel] <n> Set lower resistance limit.
<n> 1 to 200 (Ω) for 100Ω RTD or
thermistor, 5 to 2.000e3 (Ω) for 1kΩ RTD or
thermistor, 50 to 2.000e4 (Ω) for 10kΩ
thermistor, 500 to 2.000e5 (Ω) for 100kΩ
thermistor | MIN | MAX (HIGH:LEV) | DEF
50 (100Ω RTD
or ther),
5e2 (1kΩ RTD
or ther),
5e3 (10kΩ ther), or
5e4 (100kΩ ther)
[:LEVel]? Query lower resistance limit.
:TRIPped? Query if lower limit exceeded. (1 = yes;
0 = no).
:STATe <b> Enable/disable resistance protection.
(ON | OFF).
ON ✓
:STATe? Query resistance protection state. ✓
Table 10-5 (continued)
:SOURce[1] subsystem commands
Command Description Default parameter SCPI