Keithley 2510 User Manual

Models 2510 and 2510-AT User’s Manual SCPI Command Reference 10-9
:SOURce[1]
:TEMPerature Temperature commands. ✓
:ATUNe Auto Tune commands (Model 2510-AT only). ✓
:LCONstants Temperature PID loop constants. ✓
:MSETtle Use minimum settling time criteria. ✓
:GAIN? Query temperature gain constant. ✓
:DERivative? Query temperature derivative constant. ✓
:INTegral? Query temperature integral constant. ✓
:TRANsfer Accept and install MSET constants as defaults. ✓
:MOVershoot Use minimum overshoot criteria. ✓
:GAIN? Query temperature gain constant. ✓
:DERivative? Query temperature derivative constant. ✓
:INTegral? Query temperature integral constant. ✓
:TRANsfer Accept and install MOV constants as defaults. ✓
:TAU? Query tau value. ✓
:LAG? Query lag value. ✓
:STARt <n> Set start temperature value. (Not to exceed
temperature protection level.)
✓
:STARt? Query temperature start value. ✓
:STOP <n> Set stop temperature value. ✓
:STOP? Query stop temperature value. (Not to exceed
temperature protection level.)
✓
:INITiate Initiate autotune procedure. ✓
:SYSTAU Program initial skip rate for SHOR, MED, or
LONG Tau loads
:SYSTAU? Query Systau value.
:LCONstants Program temperature PID loop constants. ✓
[:GAIN] <n> Set temperature gain.
<n> = 0 to 1e5 | MIN | MAX | DEF
20.0 ✓
[:GAIN]? Query temperature gain. ✓
:DERivative <n> Set temperature derivative constant.
<n> = 0 to 1e5| MIN | MAX | DEF
0.0 ✓
:DERivative? Query temperature derivative constant. ✓
:INTegral <n> Set temperature integral constant.
<n> = 0 to 1e5 | MIN | MAX | DEF
0.6 ✓
:INTegral? Query temperature integral constant. ✓
Table 10-5 (continued)
:SOURce[1] subsystem commands
Command Description Default parameter SCPI

Keithley 2510 Specifications

General

Brand	Keithley
Model	2510
Category	Measuring Instruments
Language	English