The charging site is configured with the Commissioning Tool software. The
set-up of the charging site in ChargEye consists of the following steps:
•
Adding the new charging site to the backend system.
• Adding the general information of the charging site to the backend
system (location, owner, etc.).
• Specifying the settings (technical values, authorization).
• Specifying the access rights for different user groups and roles.
• Request new users or change of access rights from
Kempower
Technical Support.
When the charging site is configured, the following tasks can be done
through ChargEye (depending on the user's access rights):
•
Reading data and troubleshooting logs
• Updating software
• Restarting chargers
• Monitoring connection status
• Monitoring energy consumption
CHARGING EQUIPMENT FOR ELECTRIC VEHICLES INSTALLATION MANUAL
CONFIDENTIAL – CERTIFIED PARTNERS 118 REV 2.40 EN 04-2024
To Next Page
Loading...
