regulations about the type A residual-current device (RCD) required for
the supply side.
4.3. Required tools and equipment
To do installation tasks, make sure that you have the necessary tools and
equipment.
Personal protective equipment (PPE)
• Protective gloves
•
Protective eyewear
• Safety shoes
Access
• Charging power unit door key
•
Access to the main AC power
supply point
• Triangle key
• Control Unit door key
Required tools
• H3, H4, H5, H6 and H8 key
•
T25 and T30 bit
• Security T30 bit
• Screwdriver
• Electrician's crosshead screwdriver
• Electrician's flathead screwdriver
• 1/4 ratchet wrench (or your
preferred tool, to use the Allen
keys)
• Torque Wrench 1-50 Nm
• 100 mm extension (50 mm and 200
mm also recommended)
• Multimeter, capable of insulation
tests up to 1000 V
Recommended tools
• Long nose pliers
•
Side cutters
• Electric tape, multiple colors
• Work light
• Digital camera or mobile phone
with camera
Some task-specific additional tools may also be needed.
CHARGING EQUIPMENT FOR ELECTRIC VEHICLES INSTALLATION MANUAL
CONFIDENTIAL – CERTIFIED PARTNERS 41 REV 2.40 EN 04-2024
To Next Page
Loading...
