NOTICE
Do not lift the power module from its guide pins.
NOTICE
Make sure that the module's connectors and connector pins are in good
operating condition. When you push the module into the unit, be very careful
not to damage the connector pins.
5.1.10. Installing Satellite
NOTICE
Two persons are needed for this task.
NOTICE
The Satellite frame weighs approximately 50 kg without the charging cables and
support springs.
NOTICE
Do not exceed the bending radius of the cable given by the cable manufacturer.
NOTE
Use four M16 anchor bolts or equivalent per Satellite installation flange.
Install the Satellite with its installation
flange on a stable, hard surface. The
installation flange of the Satellite is part
of the standard delivery.
The standard installation flange of the
Satellite cannot be used if the Satellite
is installed in a concrete element
typically used for e.g. lamp posts. In this
case, remove the standard installation
flange and replace it with the mounting
tube (option). See 5.1.10.1: Removing
the standard installation flange of
the Satellite.
1. Make sure that:
•
The installation flange or mounting tube is tightly fixed to the
Satellite.
• The front panel has room to open when the Satellite is installed.
CHARGING EQUIPMENT FOR ELECTRIC VEHICLES INSTALLATION MANUAL
CONFIDENTIAL – CERTIFIED PARTNERS 68 REV 2.40 EN 04-2024
To Next Page
Loading...
