6.1. Needed for the task
This installation requires software configuration. Only Kempower personnel
can do the software configuration. Contact Kempower Technical Support
and make sure that they are available for remote support while you are on
site. Give the serial number of your charging unit in the support request.
Estimated time of labor 0.5 h.
Tools and equipment
• Equipment stop push button or
contactor circuit (NC, normally
closed)
•
Protective gloves
• Protective eyewear
• Power unit door key
• Access to the main AC power
supply
• Screwdriver T30
• Digital camera or mobile phone
with camera
• Clean and dry compressed air
(max. 4 bar)
• Vacuum cleaner (optional)
• Contact cleaner spray (optional)
6.2. Task
CAUTION
If you have a double or triple cabinet, only install the equipment stop circuit in the
master cabinet (first cabinet on the left).
NOTE
Remove the lowest power module, the power distribution module, the control
module, and the front panel of the mains module to make room for the
installation.
CHARGING EQUIPMENT FOR ELECTRIC VEHICLES INSTALLATION MANUAL
CONFIDENTIAL – CERTIFIED PARTNERS 106 REV 2.40 EN 04-2024
To Next Page
Loading...
