5.1.9. Installing the charging power unit
CAUTION
The module rails inside the cabinet have sharp edges. Be careful when removing and
installing modules.
NOTICE
Make sure that the AC mains power cables have been routed to the foundation
or installation location before you install the units in place. The distance from the
bottom of the cabinet to the bottom of the AC terminal blocks is approximately 290
mm.
NOTICE
Make sure that the installation surface is solid and as level as possible.
NOTICE
Make sure that the door of the unit has space to open when the unit is in position.
NOTICE
Two persons are needed for this task.
NOTE
Use four M12 anchor bolts or equivalent per cabinet.
1. Drill the fixing holes. See 9: Unit footprints and clearances.
2. Install the fixing anchors in place. If necessary, use epoxy or equivalent
to fasten them.
3. Make sure that the installation level is horizontal. If necessary,
use appropriate washers.
4. To make cable routing easier, strap the power and control cables
together with electric tape or equivalent.
5. If the steel base is used, install it in place.
• Note the cable routes and open the necessary knock-out holes of
the steel base.
• Use cable bushings or file the sharp metal edges of the knock-out
holes to protect the cables from damages.
• Route the cables into the steel base.
NOTICE
Do not exceed the bending radius of the cable given by the cable
manufacturer.
6. Fasten the door(s) of the unit in the open position with duct tape or
equivalent.
CHARGING EQUIPMENT FOR ELECTRIC VEHICLES INSTALLATION MANUAL
CONFIDENTIAL – CERTIFIED PARTNERS 66 REV 2.40 EN 04-2024
To Next Page
Loading...
