6. INSTALLING THE EQUIPMENT STOP CIRCUIT (OPTION)
WARNING
You must complete the Kempower certification training before you do installation,
commissioning, service or maintenance tasks. Installation, commissioning, service or
maintenance tasks done by an unapproved partner will void the warranty.
WARNING
You must be authorized to do electrical work. The instructions are for persons who
know electrical work and the applicable electrical safety requirements.
WARNING
After you disconnect the power supply, wait a minimum of two minutes for the
capacitors of the power modules to discharge before you continue. Before you start
work, measure the voltage of the electrical circuits to make sure that no dangerous
voltage remains.
CAUTION
Know and obey the general and local safety regulations and procedures.
NOTICE
The electrical installation must be done in dry conditions. If necessary, weatherproof
the installation area before you start the installation.
NOTICE
Two persons are needed for this task.
NOTE
The power module weighs approximately 43 kg.
NOTE
The power distribution module weighs approximately 32 kg.
CHARGING EQUIPMENT FOR ELECTRIC VEHICLES INSTALLATION MANUAL
CONFIDENTIAL – CERTIFIED PARTNERS 105 REV 2.40 EN 04-2024
To Next Page
Loading...
