Figure 38. Opening in Satellite collar for surface-installed cables
5.1.10.1. Removing the standard installation flange of the Satellite
NOTICE
Two persons are needed for this task.
NOTICE
The Satellite frame weighs approximately 50 kg without the charging cables and
support springs.
• Place the Satellite so that you can open the front panel and slide the
standard installation flange out from the bottom of the Satellite.
•
Remove the three security T30H screws and open the front panel of the
Satellite.
• Remove the busbar connectors from the installation flange.
• Remove the four H8 fixing screws of the installation flange.
• Slide out the installation flange.
Assemble in the reverse order.
CHARGING EQUIPMENT FOR ELECTRIC VEHICLES INSTALLATION MANUAL
CONFIDENTIAL – CERTIFIED PARTNERS 70 REV 2.40 EN 04-2024
To Next Page
Loading...
