• The charging cable and support spring of the Liquid Cooled
Satellite are installed on the unit at the factory. The coolant is
prefilled inside the unit. The unit is shipped upright in a crate.
•
The charging cables and support springs of the Satellite are not
installed on the unit at the factory. The unit and its charging cables
and support springs are shipped in a horizontal position in a crate.
• The charging cable of Control Unit is not installed on the unit at
the factory. The unit and the charging cable are shipped in two
separate boxes.
• Do not remove the protective packaging from the vehicle
connectors before you have installed the charging cables.
• Power Unit and Station Charger shipments have a tilt indicator.
Shipments of other products may also have a tilt indicator. If the
tilt indicator indicates mishandling, do not start the installation. For
assistance, contact
Kempower Technical Support.
•
Know the site's electrical installation plan before you start mechanical
installation.
• If an emergency stop circuit is included, make sure that it is in place
before you start installation.
• Make sure that the AC mains power cables of the charging power unit
have been routed to the foundation or installation location before you
install the charging power unit in place.
• Make sure that the connection cables have been routed from
the charging power unit to the charging point before you install the
charging point in place. The connection cables are routed to the Liquid
Cooled Satellite frame that has the user interface.
• Make sure that the AC mains power cables and the communication
cable (optional) have been routed to the AC Satellite before you install
it in place.
CHARGING EQUIPMENT FOR ELECTRIC VEHICLES INSTALLATION MANUAL
CONFIDENTIAL – CERTIFIED PARTNERS 43 REV 2.40 EN 04-2024
To Next Page
Loading...
