Konica Minolta 240f 8-39
8.2 Specifying default settings
8
List of other default settings
Function Description Settings Reference
page
Redial Attempts This sets the number of redials when the oth-
er machine cannot be connected to, for ex-
ample, when the other line is busy. Set the
redial interval in "Redial Interval".
0 - 15 time(s):
2time(s)
p. 4-16
Redial Interval This sets the redial interval. 0 - 5 Minutes :
1 Minute
p. 4-16
Number of Rings This sets the number of times the machine
rings until fax reception starts when the re-
ception mode is set to Fax or Tel/Fax. The
number of rings becomes more than the set
number when the machine is in the low power
mode.
0 - 10 time(s):
2 time(s)
p. 4-25
Dialing Pause This sets the default dialing interval used
when the pause option is input.
0 - 10 seconds:
2 seconds
p. 4-20
S-Fine Resolution This sets the scanning resolution to use when
super fine resolution is set for transmission.
When set to 600 dpi, the image quality will be
higher than with 400 dpi, but the machine
may run out of memory when performing the
transmission.
600 dpi
400 dpi
p. 4-18
Rx Reduction Rate Select from "Auto", which automatically se-
lects the magnification according to the
length of the document being received, or
"100%" to have all faxes printed out at the
same rate of reduction.
Auto
100 %
p. 4-31
Reduction Margin This sets at what point the document printout
will extend to the following page if the docu-
ment being received cannot fit within the ef-
fective recordable area.
0 - 85mm:
24 mm
p. 4-32
Paper Saving This sets the print method for received docu-
ments.
OFF
H-Page Rx
Duplex Rx
p. 4-33
Quick Memory Tx If this is set to "ON", fax transmission for mul-
tiple documents will begin in order of page
when it has been scanned and stored.
ON
OFF
—
ECM Mode This mode enables any part of a fax that was
not transmitted correctly due to a line error
will automatically be resent. (The destination
machine must also have the same function.)
ON
OFF
—
Service Mode Do not set this. ON
OFF
—
Prefix By registering frequently used fax numbers,
you can enter a fax number simply by press-
ing a button.
Up to 40 digits can be entered for a prefix
number. Numbers, #, *, /P (Pause), and /T
(Tone) can be entered.
(Not registered) p. 4-20
Receive Time Stamp Prints the time that documents are received.
This enables you to accurately manage the
arrival time of received documents.
ON
OFF
—
Auto Print Journal You can print a list of communication jobs. ON
OFF
Reserve print
p. 7-8
Journal Line Up You can select whether to arrange printed
journal reports in order of job or in order of
communication number.
OFF
ON
p. 7-7
To Next Page
Loading...
