Operating Instructions 6-15
D-H023.0906EN
innovators in agriculture
8. Select [Close].
9. Remove the plug (1) from the knee (2).
10. Install the nipple (3) with the hose (4) into the hole in the knee.
11. Select [Next].
12. Make sure the value in the field Current rack number is correct.
13. If necessary:
1. Select [Change].
2. Type the correct value in the calculator.
3. Select [ENTER].
14. Make sure the values in the fields Start position (bottle number)
and End position (bottle number) are correct.
15. If necessary:
1. Select [Change].
2. Type the correct value in the calculator.
3. Select [ENTER].
16. Make sure the value in the field No. of empty bottles for alarm is
correct.
17. If necessary:
1. Select [Change].
2. Type the correct value in the calculator.
3. Select [ENTER].
18. Make sure the value in the field Fill time sample bottle is correct.
19. If necessary:
1. Select [Change].
2. Type the correct value in the calculator.
3. Select [ENTER].
20. Select [Next].
21. When the screen changes to The Shuttle is operational, Cows are
not marked for sampling, select [Mark all cows] and [OK] in the
field Cow activation.
22. Start the sampling in the T4C software (refer to the T4C manual).
6.8.2 Change Sample Rack
On the X-Link:
1. Select Tab [Sampling].
2. In the field Progress select Change.
3. When the screen changes to Sample rack, Current rack number:
1. Select [Change].
2. Type the correct value in the calculator.
To Next Page
Loading...
Need help?
General
