LELY ASTRONAUT A3 Next - Interrupt Pre-Treatment; Reconnect the Teat Cups; Prolong Milking; Interrupt Post Treatment

Operating Instructions 6-9
D-H023.0906EN
innovators in agriculture
6.2.3 Interrupt Pre-Treatment
1. Select Tab [Process].
2. In the field Attachment system, select [Interrupt pretreatment].
3. When the pop-up window Confirm user interruption of this visit
appears, select [Stop].
6.2.4 Reconnect the Teat Cups
1. Select Tab [Process].
2. In the field Attachment syste, select [Reconnect teat cups].
3. When the pop-up window Confirm user interruption of this visit
appears, select [Yes].
4. Position the robot arm under the cow in front of the udder with
the arm control buttons (page 4-36).
5. Make sure the rear teat cups are under the front teats and the laser
bundle nearl (fig. 19
, page 6-8)y touches the rear teats.
6. When the rear teat cups are in the correct position, select [Start
connection].
6.2.5 Prolong milking
Note:
The system settings for the cow are overruled temporary.
1. Select Tab [Process].
2. In the field Milking select [Prolong milking].
3. When the pop-up window appears, select [Prolong 5 min.].
6.2.6 Interrupt Post Treatment
1. Select Tab [Process].
2. In the field Attachment system select [Interrupt posttreatment].
3. When the pop-up window Confirm user interruption of this visit
appears, select [Stop].