7-44 Maintenance
D-H023.0906EN
innovators in agriculture
Confirm
1. Make sure the following Astri-products are available:
• Astri-Lin
• Astri-Cid
• Astri-L
• Astri-UC (optional).
2. If these Astri-products are not (all) available and in use, write it
down on the visit report.
3. Make sure there is sufficient Astri fluid in the containers.
4. If necessary, replace the containers with a full one when the level is
too low.
5. Make sure the hoses go to the correct container:
• The red hose goes to the Astri-Cid container
• The blue hose goes to the Astri-Lin container
• The green hose goes to the Astri-L container
• The transparent hose goes to the Astri-UC container (optional).
6. If necessary, reconnect the applicable tubes.
7. Make sure the hoses are sufficiently into the liquid to suck correctly.
Close-up
1. Close the doors of the machine room.
2. Unblock the cow traffic.
3. Put the milking robot in operation with the X-Link (page 6-1).
7.10.3 Examine the Cleaning Brushes
Preparation
1. Take the milking robot out of operation with the X-link (page 6-1).
2. Move the robot arm to the service position (page 6-11).
Examine
1. Make sure there are enough hairs with sufficient length on the
brushes to clean the teats.
2. If there are not enough hairs with sufficient length on the cleaning
brushes, replace the cleaning brushes (page 7-45).
Close-up
1. Move the robot arm to the home position.
2. Put the milking robot in operation with the X-link (page 6-1).
To Next Page
Loading...
