Maintenance 7-43
D-H023.0906EN
innovators in agriculture
12. Slide the filter sock and the spring in the filter housing until
approximately 15 cm (5.90 in) of the filter sock is outside the filter
housing.
13. Hold the filter housing in position below the milkline and push the
filter sock fully into the tapered part of the milkline.
14. Connect the cap to the filter housing and tighten the cap hand-
tight.
15. Push [ENTER].
7.10 Cleaning Systems
7.10.1 Confirm the Availability of Astri-TDS
Confirm
1. Make sure you have Astri-TDS for cleaning the sTDS window.
2. If the Astri-TDS is not available, order it.
7.10.2 Confirm the Use of the Correct Astri-Products
Preparation
WARNING
Block the cow traffic to the milking robot before you do this
procedure.
WARNING
The Astri-products are a chemical hazard. Always wear protective
gloves when you do work on the Astri-products.
WARNING
Do NOT use chlorine products in the cleaning system. Lely Industries
N.V. is not liable for, and does not cover under warranty, any damage
or harm due to the use of other cleaning products than Astri-products
in the cleaning system.
WARNING
Do NOT mix up the Astri-products when you replace the containers.
1. Take the milking robot out of operation with the X-Link (page 6-1).
2. Open the doors of the machine room.
To Next Page
Loading...
Need help?
General
