Safety 2-3
D-H023.0906EN
innovators in agriculture
2.3.2 Electrical Safety
• Only an authorized electrician must install the electrical power supply
for the milking robot
• Make sure the electrical grounding of the electrical system and all
parts of the milking robot meet the local rules and regulations
• Make sure all electrical switches are in the OFF position before you
switch on the electrical power supply
• Replace any damaged electrical lines, conduits, switches and
components immediately
• Isolate the electrical power supply at the master panel before you
open the electrical panel to work on the electrical system.
2.3.3 Installation Safety
• The robot weighs approximately 1,550 kg (3410 lb.). Always use the
correct lifting equipment when you move the milking robot
• Read and understand the instructions in the Building Specifications
and Installation Manuals
• A fork lift truck can use the carrying frame on top of the box to move
the milking robot
• A special wheel kit can be used to move the milking robot on flat
(including slatted) floors
• The robot is not stable until it is correctly installed, make sure it is
correctly supported at all times during movement and installation
• Make sure the milking robot is correctly installed in the barn
• The milking robot must be installed in a horizontal position. If
necessary, install filler pieces to make sure the floor of the robot is
horizontal
• Make sure the electrical power supply is correct before you connect it
to the milking robot
• Only an authorized electrician must install the electrical power supply
for the milking robot
• Make sure the electrical grounding of the electrical system and all
parts of the milking robot meets the local rules and regulations.
2.3.4 Operating Safety
• Read and understand the applicable manual and all safety signs
before you connect power supplies to operate, maintain or adjust the
milking robot
• Only trained persons are permitted to operate the milking robot
• Do NOT use chlorine products in the cleaning system. Lely Industries
N.V. is not liable for, and does not cover under warranty, any damage
or harm due to the use of other cleaning products than Astri-
products in the cleaning system.
• Do NOT mix up the Astri-products when you replace the containers.
• SWITCH OFF the milking robot, disconnect and isolate the electrical
power supply, release pneumatic pressure and wait for all moving
parts to stop before you clean or do maintenance on the milking
robot
• Install all covers and guards before you operate the milking robot
• Keep hands, feet, hair and clothing away from all moving parts
• Keep unauthorized persons, especially small children away from the
milking robot at all times
To Next Page
Loading...
Need help?
General
