7-12 Maintenance
D-H023.0906EN
innovators in agriculture
7.4.4 Remove or install the Lower Arm Cover
Removal
1. Remove the screws (2, fig. 31,
page 7-12).
2. Remove the lower arm cover (1).
Installation
1. Make sure the tubes and the cables are in the correct position and
install the lower arm cover (1, fig. 31,
page 7-12).
2. Install the screws (2).
Figure 31. Remove or install the lower arm cover
7.4.5 Remove or install the Mothership Cover
Removal
1. Remove the lower arm cover (page 7-12).
2. Remove the screw (6, fig. 32,
page 7-13) while holding the threaded
bracket (5).
3. Put the threaded bracket (5) on a safe place.
4. Loosen the bolts (1) and (2) until the mothership cover (3) can move
easily.
CAUTION
Make sure the sTDS cable does not become tight or damaged when you
remove the mothership cover.
To Next Page
Loading...
Need help?
General
