LELY ASTRONAUT A3 Next - Clean the Outside of the Teat Cups

Maintenance 7-19
D-H023.0906EN
innovators in agriculture
Close-up
1. Move the robot arm to the home position.
2. Start the local rinse procedure with the X-Link (page 6-10).
3. Put the milking robot in operation with the X-link (page 6-1).
Figure 36. Clean the bleed holes
7.7.2 Clean the Outside of the Teat Cups
CAUTION
Do not use a high pressure cleaner to clean the teat cups. Damage to the teat
cups may occur.
Preparation
1. Take the milking robot out of operation with the X-link (page 6-1).
2. Move the robot arm to the service position (page 6-11).
Clean
1. Use a bucket of water and a brush, or a soft spray hose to clean the
outside of the teat cups.