Test and Adjustment 8-9
D-H023.0906EN
innovators in agriculture
8.6.3 Manually add the Milk Separation of a Cow
Note:
Refer to the T4C Operator Manual
CAUTION
Make sure to follow the procedure:
1. Complete this form.
2. Do the treatment.
3. In case of a milk separation, make sure the milk separation is confirmed by
the milking robot.
1. In the navigation bar, select 'Data Entry' and 'Daily entry'.
2. From the action list, select 'Milk Separation'.
3. Enter the cow's number in the field 'Select Cow(s)'.
4. Select button [Select].
5. Select button [Submit].
A new window opens.
6. Complete the form.
CAUTION
T4C sends the milk separation settings directly to the Astronaut A3 milking
robot(s).
7. Select button [Save].
The settings are processed and the process steps ('Created', 'Send'
and 'Confirm') are displayed in a popup window. When the process
is finished, select button [Close] to close the window.
CAUTION
If the Confirm icon is not a green check mark, the separation is not confirmed
by the milking robot(s) and therefore the milk is not separated.
To Next Page
Loading...
Need help?
General
