9-2 Troubleshooting
D-H023.0906EN
innovators in agriculture
3. If the problem remains:
1. Make sure the cubicles and the passages are clean.
2. Make sure the cow's udders are shaved and the tails are cut
(page 6-4).
9.5 The Udders are not clean before the Milking starts
1. Make sure the brushes are clean after brush cleaning (page 9-1).
2. Make sure the cubicles and the passages are clean.
3. Make sure the cow's udders are shaved and the tails are cut (page
6-4).
4. Use more litter in the barn.
5. Increase the quantity of pre-treatments until the udders are clean.
6. Reset the quantity of pre-treatments to the default value (2).
9.6 Cleaning Brushes are dry
Note:
This occurs when the cleaning process is disturbed.
1. Make sure the water supply is ON.
2. Restart the robot with the option 'Empty boiler' (page 6-2).
9.7 X-Link is OFF
1. Make sure the main power supply is ON and the fuses are not
blown.
2. Make sure the power supply is ON (page 7-4).
3. Make sure the circuit breakers are ON (page 7-4).
4. If the problem remains, call your local Lely service provider.
9.8 Alarm System does not generate a Phone Call during the
Night
1. Make sure the telephone system is functioning correctly.
2. Make sure there are no active alarms (page 6-17).
3. Make sure the alarm system settings are correct (page 8-14).
4. Test the alarm on the CRS+ (page 4-46).
To Next Page
Loading...
