ix
D-H023.0906EN
innovators in agriculture
Technician Training
All the technicians certified by Lely Industries have completed an
approved training program, and passed written and practical
examinations during and at the end of the training program. The
training is given by a product specialist. The examinations are done
under supervision of a master product specialist and include
troubleshooting and corrective maintenance of the ASTRONAUT A3
Next.
There are five certification levels:
• Installation Technician (certification valid for two years)
• Service Engineer (certification valid for two years)
• Senior Service Engineer (certification valid for two years)
• Product Specialist (certification valid for one year)
• Master Product Specialist (certification valid for one year).
During training, a trainee is permitted to work for up to a maximum of
six months under close supervision of a certified technician. A trainee
can do work on the milking robot can only in the presence of a certified
technician.
When the training program is completed successfully, Lely issue a
certificate and a service pass to the technician. The service pass contains
the following information:
• The name of the technician
• A photograph of the technician
• The certification number of the technician
• The date of expiry of the certification.
Local Maintenance Contact Number
We suggest you write the telephone number and email address of your
local maintenance contact in the table below. This makes sure you can
easily find the information.
Telephone number
email address
To Next Page
Loading...
Need help?
General
