Lexmark CX310dn - Page 151

Error code Description Action
882 Failure to transmit training successfully in V17,
V29 terminal modulation schemes.
• Select a lower “Max Speed” under Fax
Send settings.
• Adjust the “Transmit Level”.
• Check line quality.
883 Failure to transmit training successfully in V17,
V27 terminal modulation schemes.
• Select a lower “Max Speed” under Fax
Send settings.
• Adjust the “Transmit Level”.
• Check line quality.
884 Failure to transmit training successfully in V29,
V27 terminal modulation schemes.
• Select a lower “Max Speed” under Fax
Send settings.
• Adjust the “Transmit Level”.
• Check line quality.
885 Failure to transmit training successfully in V17
terminal modulation scheme.
• Select a lower “Max Speed” under Fax
Send settings.
• Adjust the “Transmit Level”.
• Check line quality.
886 Failure to transmit training successfully in V29
terminal modulation scheme.
• Select a lower “Max Speed” under Fax
Send settings.
• Adjust the “Transmit Level”.
• Check line quality.
887 Failure to transmit training successfully in V27
terminal modulation scheme.
• Select a lower “Max Speed” under Fax
Send settings.
• Adjust the “Transmit Level”.
• Check line quality.
888 Failure to transmit training successfully at 2400
bps in V27 terminal modulation scheme.
• Adjust “Transmit Level”.
• Check line quality.
889 Failed to connect at the minimum speed
supported by the MFP.
• Adjust “Transmit Level”.
• Incompatible connection.
88A Failed to connect using V.34 modulation
scheme.
• Check line quality.
• Adjust to a lower modulation scheme.
• Adjust Transmit Level Receive Threshold
values.
901 No fax tones detected from remote end.
• Verify destination phone number.
• Verify that the remote fax is authorized
to receive faxes.
902 No dial tone detected.
• Check by enabling ‘Behind a PABX’
setting.
• Check phone line.
• Check MFD modem hardware.
7527
Diagnostic information
151