4 Remove the screw (B) securing the AIO release lever to the flatbed.
5 Slide the AIO release lever towards the back of the flatbed.
6 Remove the spring and AIO release lever.
Installation note: When reinstalling the AIO release lever, place the release lever on the flatbed, and then inset
the spring before replacing the screw.
Bin‑full flag removal
1 Lift the scanner assembly and lock it into the up position.
2 Gently disconnect the three snaps (A) from the rear shaft of the redrive unit.
7527
Repair information
238
To Next Page
Loading...
