7 Remove the two screws (B) at the top left and right holding the operator panel assembly, the upper front cover,
and the user interface bracket together.
8 Pull the left and right sides of the upper front cover out enough to slide the operator panel assembly and bracket
away from the cover.
9 Remove the two screws (C) holding the operator panel assembly to the user interface bracket.
10 Disconnect the flat cable from the controller card to the UICC.
Note: All of the FRUs listed above are now easily accessible.
Paper pick motor drive assembly (standard tray) removal
1 Remove the waste toner bottle. See “Waste toner bottle removal” on page 304.
2 Remove the imaging unit. See “Imaging unit (IU) removal” on page 266.
3 Remove the left cover assembly. See “Left cover assembly removal” on page 219.
4 Remove the rear cover. See “Rear cover removal” on page 221.
5 Disconnect the paper pick motor drive assembly cable connector (A) from JSP1 on the controller board.
6 Pull the cable (B) through the opening, and free the cables from their retainers (C) on the left.
7 Partially reinstall the rear cover to protect the controller board, and turn the printer so that the rear cover rests on
the table. The bottom should be facing you.
Warning—Potential Damage: For models with a wireless antenna, use supports to prevent the antenna from
taking the weight of the printer.
7527
Repair information
290
To Next Page
Loading...
