10 Disconnect the cable (E) from the controller board at JSC1.
Installation note: Notice the assembly of the cable and toroid (if used), and reassemble the new contacts in the
same manner.
11 Remove the cable from the retainer on the bottom of the printer.
Toner density sensor (TDS) (left or right sensor) removal
Note: The toner density sensor is also called the toner patch sensor (TPS).
Note: The toner density sensors are the same, but the left sensor has a thermistor attached which needs to be
removed when you install a new TDS on the left side. Reinstall the thermistor on the new TDS.
1 Remove the transfer module. See “Transfer module removal” on page 300.
2 Remove the rear cover. See “Rear cover removal” on page 221.
7527
Repair information
296
To Next Page
Loading...
