4 Remove the sensor plate (D).
5 Push in on the latches to disconnect the duplex sensor from the printer.
6 Disconnect the cable (E) from the duplex sensor.
Installation notes:
a Clean the contact surface where you removed the sensor retaining plate, or where you need to install the new
one.
b Install the new sensor.
Note: Make sure the clamps on the legs of the sensor latch to the metal frame.
c Remove the backing from the new plate, and place the plate on the surface between the sensor mounting
latches.
EP drive assembly removal
1 Remove the left cover assembly. See “Left cover assembly removal” on page 219.
2 Remove the transfer module. See “Transfer module removal” on page 300.
7527
Repair information
245
To Next Page
Loading...
