Lexmark CX310dn - Operator Panel Removal (for CX310 and CX410 Models Only)

Operator panel removal (for CX310 and CX410 models only)
Installation warning: Replace one of the following components, and perform a POR before replacing a second
component. Never replace both of the components without performing a POR after installing each one, or the
printer may be rendered inoperable:
• Operator panel assembly
• Controller board
Note: The UICC card is part of the operator panel.
Note: The following parts (FRUs) can be accessed from this section:
• Operator panel (one for each CX310 and CX410)
• Display and PCBA (CX310)
• Display (CX410)
• UICC PCBA (CX410)
• User interface support bracket (common to CX310 and CX410)
• Front operator panel cover (common to CX310 and CX410)
• Upper front (operator) cover (common to CX310 and CX410)
• Speaker (CX410)
1 Lift the flatbed scanner assembly on the right side.
2 Remove the three screws (A) from beneath the operator panel.
7527
Repair information
283