Connector Connects to Pin no. Signal
JSP1 Smart pick drive (paper pick motor drive
assembly)
• Encoder—pins 1, 3, 5, 7, and 9
• Smart pick—pins 2, 4
• Motor—pins6, 8, 10, 12
• Input (S2) sensor—pins 13–16
1ANODE (no wire)
2 +24 V dc M1_OUT1 (0 V dc with door open)
3 Ground (no wire)
4 +24 V dc M1_OUT2 (0 V dc with door open)
6 Ground (no wire)
7 Ground
10 +5 V dc
13 Ground (no wire)
15 +5 V dc
16 Ground
JTHM1 TPS thermistor connector 1 +1.5 V dc TPS_THERM_SNS
2 TPS_SNS_RTN, ground
JSPKR1 Speaker N/A Not testable in the field
JTPS1 Toner patch sensor 1 3 Ground (no wire)
5 Ground
JTPS2 Toner patch sensor 2 3 Ground (no wire)
5 Ground
JTRAY1 Tray present sensor 2 +3.3 V dc
3 Ground
JUSB1 Port USB connector N/A N/A
JWIRE1 USB wireless connector N/A Not testable in the field
JWT1 Waste toner detection 3 +1.5 V dc
4 Ground (no wire)
7527
Component locations
317
To Next Page
Loading...
