Doc #: L-2600-1023 Page 12 Rev. 02
3.1.1 ACC Softkey
This is a quick access key. This key will supply direct access from any screen to the Quick Access
screen. The quick access screen contains the name of the currently logged in user, the log out softkey,
and access to auxiliary communications.
3.1.2 Espanol/English Softkey
This changes the display language from English to Spanish or Spanish to English. If the display is
currently in English, touching the Espanol softkey will change the display to Spanish. If the display is
currently in Spanish, touching the English softkey will change the display to English.
3.1.3 RUN/PROG (Run/Program) Switch
This is a keyed selector switch read directly by the System 2600. The PROG (program) position causes
the unit to assert a Top Stop, and prevents machine initiation until the switch is returned to the RUN
position. There are several user access modes that will require the operator to turn the keyed selector to
the PROG position in order to modify parameters. This switch must also be in the PROG position for
unit configuration.
3.1.4 Automatic LCD Turn Off
To increase the life of the display backlight, the backlight will automatically dim ten minutes after the
last production cycle is detected AND the operator terminal detects no user activity. User activity for
this purpose is defined as pressing the touch screen or operating the RUN/PROG switch. The backlight
is turned back on and the ten-minute timer is reset any time the touch screen is pressed on the operator
interface or the RUN/PROG key is operated.
3.1.5 Parameter Entry
Throughout the operator interface, a standard form of data entry is employed. Parameters that can be
changed are indicated by a hollow blue box with the parameter inside. Touch inside the hollow blue box
to edit the parameter.
To Next Page
Loading...
General