Doc #: L-2600-1023 Page 52 Rev. 02
Dec. Scrap key is pressed, then 1 is subtracted from the scrap count and 1 is added to the part and bin
count. If the scrap count value is edited by pressing inside the blue bordered box showing the count,
then the part and bin count is not affected. When the counter group is “Sensor Based”, then the scrap
count is incremented each time the corresponding scrap counter hardware input is triggered without
affecting the part or bin count.
3.5.2.5 Changing the Count for Production Counters
The current count value of a production counter can be changed. If an access control mode (see section
3.1.7 on page 14) is being used that requires a password, a user must be configured to have the “Counter
Change” permission to change this parameter.
The current count is changed by touching the counter field of the desired counter and entering the new
value. The numeric entry screen provides softkeys to increment or decrement the counter or a new
number can be entered.
3.5.3 Cycle Counter
The cycle counter increments anytime the crankshaft travels from the top of the stroke to the bottom of
the stroke. Contact Link Systems service department to reset the cycle counter.
To Next Page
Loading...
General