Doc #: L-2600-1023 Page 72 Rev. 02
The user must have access control to perform a job erase. Access control is described in section 3.1.7 on
page 14. If an access control mode is being used that requires a password, a user must be configured to
have the “Erase Jobs” permission to erase a job.
5.4 Data Storage
All settings are stored on the Micro-SD card located on the circuit board in the door of the unit. If
necessary, the 2600-2 board (the board in the bottom of the enclosure) can be swapped between units
and will still receive the proper settings for that press.
5.5 New Die Installation
In normal operating conditions, the job recall function is used to load the system with the settings and
parameters for the die being used. However, when a new die is installed in the machine, these settings
may not be defined. The settings presently in the unit remain in effect and may cause issues when the
press is run. Carefully review the current settings and make needed adjustments before running the
press. After the correct settings are established for the die, along with all other system settings, the
present settings should be stored under a job number and description for recall later.
To Next Page
Loading...