Loop Telecom IP6610 - Page 163

Chapter 21 Appendix A: Operation Commands
140
Syntax: set svlan pcp action
Explanation:
Set the svlan tag drop eligible indicator bit
Parameters:  action
enabled/disabled
Command: >set svlan ingress-filter
Privilege:
Admin
Syntax: set svlan frame-type action interface[sub-interface]
Explanation:
Enable/disable ingress filtering for one port.
 action
enabled/disabled
 interface
Interface Name. (lan1/wan1)
Parameters:
 [sub-interface]
Interface Name. (pvc1-pvc10)
Command: >set svlan mgmt
Privilege:
Admin
Syntax: set svlan mgmt vid
Explanation:
Set management SVLAN ID for the bridge
Parameters:  vid
SVLAN ID. Range from 1-4094
Command: >set svlan pcp
Privilege:
Admin
Syntax: set svlan pcp value
Explanation:
Set the svlan tag priority code point
Parameters:  value
0-7
Command: >set svlan port-type
Privilege:
Admin
Syntax: set svlan frame-type type interface[sub-interface]
Explanation:
Set the acceptable frame type of one port
 type
provider/customer
 interface
Interface Name. (lan1/wan1)
Parameters:
 [sub-interface]
Interface Name. (pvc1-pvc10)
Command: >set svlan pvid
Privilege:
Admin
Syntax: set svlan frame-type vid interface[sub-interface]
Explanation:
Set Interface PVID
 vid
SVLAN ID. Range from 1-4094
 interface
Interface Name. (lan1/wan1)
Parameters:
 [sub-interface]
Interface Name. (pvc1-pvc10)
Command: >set svlan regencrc
Privilege:
Admin
Syntax: set svlan mgmt action
Explanation:
Enable/disable regenerating CRC on WAN interface for VLAN frames. Show warning msg
Parameters:  action
enabled/disabled
Command: >set svlan remove
Privilege:
Admin
Syntax: set svlan remove vid interface [sub-interface]
Explanation:
Remove a port from one SVLAN.