Loop Telecom IP6610 - Page 164

Chapter 21 Appendix A: Operation Commands
141
 vid
SVLAN ID. Range from 1-4094
 interface
Interface Name. (lan1/wan1)
Parameters:
 [sub-interface]
Interface Name. (pvc1-pvc10)
Command: >set svlan tpid
Privilege:
Admin
Syntax: set svlan tpid value
Explanation:
Set the svlan tag type
Parameters:  value
2 bytes, default value 8100
Command: >set vlan add
Syntax: set vlan add vid tag-type interface-name
Explanation: Add a bridge interface to be one tagged/untagged member for a specific VLAN.
Parameters: vid (VLAN ID, range from 1 to 4094)
Tag-type: tagged or untagged
Interface-name: such as “lan1”, “wan1”, or “wan1 pvc1”….
Command: >set vlan create
Syntax: set vlan create vid
Explanation: Create a VLAN
Parameters: vid (VLAN ID, range from 1 to 4094)
Command: >set vlan deactivate
Syntax: set vlan deactivate vid
Explanation: Deactivate a VLAN
Parameters: vid (VLAN ID, range from 1 to 4094)
Command: >set vlan pvid
Syntax: set vlan pvid vid interface-name
Explanation: Setup the PVID for one bridge interface. (Default: is 1)
Parameters: vid (VLAN ID, range from 1 to 4094)
interface-name: such as “lan1”, “wan1”, or “wan1 pvc1”….
Command: >set vlan frame
Syntax: set vlan frame type interface-name
Explanation: Setup the acceptable frame type for one bridge interface. (Default: all)
Parameters: type : all or tag-only
Interface-name: such as “lan1”, “wan1”, or “wan1 pvc1”….
Command: >set vlan ingress-filter
Syntax: set vlan ingress-filter action interface-name
Explanation: Enable or disable the ingress filtering ability for one bridge interface.(Default: disabled)
Parameters: action: enabled or disabled
Interface-name: such as “lan1”, “wan1”, or “wan1 pvc1”….
Command: >set vlan mgmt
Syntax: set vlan mgmt vid
Explanation: set the VLAN to the bridge it belongs to. (Default : VLAN ID 1)
Parameters: vid (VLAN ID, range from 1 to 4094)